|
| Author |
Message |
ilanboni
New Member
Joined: 18 Nov 2007
Posts: 1
|
 Posted: Sun Nov 18, 2007 3:55 pm Post subject: wifi problems linksys WVC54GC |
 |
|
Hello guys...
I bought an IP camera of Linksys and it work well with the ethernet cable...
Problem is that if i remove the cable (after installed all the settings of my network) it does not work...
I tried to remove the protections, and i try to enter the camera through my pocket pc (that does not have any firewall) but nothing....
Could someone help me?
Pls, it's very urgent....thank u in advance
|
|
| Back to top |
|
 |
shopper
New Member
Joined: 19 May 2008
Posts: 2
|
| Posted: Tue May 20, 2008 5:44 am Post subject: WVC54GC |
|
|
I have three of these WVC54GC Cams. I've had them over a year. Same problem. They work great on ethernet cable, but If i remove the cable (after installed all the settings of my network) it does not work...
I'm 61 yrs old. Maybe I'm a little dense. But I tried everything I can think of.
Can enyone help me with this? I realy would like to go wireless.
|
|
| Back to top |
|
|
hackerjoe
New Member
Joined: 07 May 2008
Posts: 7
|
| Posted: Tue May 27, 2008 9:48 am Post subject: Linksys |
|
|
Is your wireless network secured on your Router ? HAve you gone into the camra settings to setup the wireless ?
You need to post everything you have tried to do to better help you.
|
|
| Back to top |
|
|
shopper
New Member
Joined: 19 May 2008
Posts: 2
|
| Posted: Tue May 27, 2008 8:36 pm Post subject: Re: Linksys |
|
|
| hackerjoe wrote: | Is your wireless network secured on your Router ? HAve you gone into the camra settings to setup the wireless ?
You need to post everything you have tried to do to better help you. |
My network is secured. I did go into the camara and set up the wireless.
My cams can be seen on the internet. Everything works great, except, I can't drop the e-cable and be "wireless". All I was told to do by Lynksys is, once all the setup was done, and everything was working, just unplug the power to the cam, drop the e-cable for about a minute, then just plug the power back to the cam. Wait a little bit and do a search with the Lynksys viewer and
your cam should com back on line. Never does.
|
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
