enable wireless camera w/o using ethernet cables (DCS-5220)

[suyadang]

what are the steps in configuring it to wireless mode?
(Note: camera's ethernet cable is connected to router)
basically what i did was follow my manual:
1. i choose the setup tab of the url location
2. uncheck the disable wireless connection,(WLAN)
3. put my Wifi username, (SSID)
4. infrastructure mode,
5. WEP security
6. 64 bits,
7. HEX,
lastly
8. entering my router password

Then i save the settings and it loads for a while, after that i disconnected the ethernet cable connected to the camera hoping to find out its wireless already. The result was the camera was disconnected. Please guide me with the correct steps i dont want to waste time with this. This is part of my project work Any help are appreciated.

[buellwinkle]

You probably need to boot your cameras, so unplug it from the wall and plug it back in.
_________________
For network camera articles and reviews, visit my blog at http://ipcamnetwork.wordpress.com

[Aliazaky]

How to boot the camera?

Suyadang did you solved your problem, I'm having same problem with you.

[buellwinkle]

Disconnet the power and plug it back in, that's the only way I know how to reboot many of these cameras.
_________________
For network camera articles and reviews, visit my blog at http://ipcamnetwork.wordpress.com