DCS-5220 Forum Posts - Pre-Sales Questions and Post-Sales Support
Below are a list of posts containing sales and support questions. These have been taken from the NetworkCameraReviews.com Forums. If your question is not found, please feel free to register on our forums to find the answers you need. You can register for an account here.
enable wireless camera w/o using ethernet cables (DCS-5220) what are the steps in configuring it to wireless mode?
(Note: camera's ethernet cable is connected to router)
basically what i did was follow my manual:
1. i choose the setup tab of the url location
2. uncheck the disable wireless connection,(WLAN)
3. put my Wifi username, (SSID)
4. infrastruc...
DCS-5220 nothing recorded or sent (motion detection) Hello,
I've installed a DCS-5220 (firmware 1.05) and tried to configure the motion detection as it's supposed to be used as a surveillance camera.
I've configured mail,FTP and Samba as follow:
Mail: Using my ISP SMTP to a gmail.com address.
FTP: A "camftp" account created on my L...
D-link DCS-5220 for babymonitor I thinking to buy a D-link DCS-5220[url]http://www.dlink.com/products/?pid=546[/url] for using as a babymontior. Would this be a good choice?
Here are my needs:
* needs WiFi
* audio
* infrared for low light (primarily we want to keep an eye on him at night)
* decent quality video
* max ...
D-Link DCS-5220 wirless set up problems Apologies in advance for the post if there are already similar posts out there.
I've been trying to setup my D-link DCS5220 via a internet browser (Because I'm on a mac) I can connect to it via its IP no problem when it is hooked up to the router, but once I un-plug it. There seems to be no way i...
D-Link DCS-5220 recording to NAS My DCS-5220 is supposed to be able to support the recording to NAS and I'm currently using QNAP.
Yes, the video clips did recorded on the NAS but the maximum file size which I can use with the supplied software is only 500KB which means I can only record clips of less than 1 minutes. That means...
